CIVIC4G.COM Menu header

Brake upgrade "Jonathan Mod"

The DIY forum
Forum rules
Please post any new articles in the "Tech Discussion" forum. After approval the thread will be moved to this forum.

DISCLAIMER PLEASE READ! or the authors of the articles cannot be held liable for any consequences whatsoever of the information or advice they provide.
DIY can go wrong, with expensive or even dangerous consequences, and it therefore must be stressed that nothing should be attempted without applying common sense, and only if you are confident in your ability to carry out the job with safety. You cannot expect answers to your questions to include a complete list of possible pitfalls. Remember that the advice has been given to you in good faith for free, and neither its accuracy nor legality can be relied upon.
If you are unsure about anything then do please ask!

Brake upgrade "Jonathan Mod"

Postby 4g4door » Thu Jan 03, 2008 4:44 am

Jonathan Mod

Well'll be glad to hear that it isn't necessary to hunt down those scarce EX knuckles to upgrade to 10.2" brakes. This bolts onto the non-EX 88-91 Civic/CRX knuckles!
Want to know how it's done?

Read on below to discover the beauty of the Jonathan Mod

Parts list:

    '91 Civic EX Brake rotors...same as 92-95 Civic Sedan rotors ($14.99 each at Pep Boys; probably cheaper at AutoZone)

    Accord Wagon Brake Calipers (will be stamped 17CL15VN; ~$50 rebuilt at Pep Boys). These are the exact same calipers as the ITR, Legend, Prelude VTEC etc. Great stopping power!

    Accord Wagon, Prelude VTEC (etc) Brake Caliper mount stamped 25T (a 23T bracket exists, but I can't promise you it will work). This is what came stock on the Accord Wagon.

    1/8" wheel spacer OR grind ~1/8th" (2.5-3mm) off of the caliper mounting bracket. If you are familiar with the 11" brake upgrade, this is the same modification necessary.

Now, the installation...

First, you need to place the wheel spacer (or washers if you're ghetto) between the hub and your new 10.2" brake rotor.

OR shave off the ~1/8" necessary from the caliper bracket

Next, Install your rotor, mount the caliper, load the pads....(you know how to do all this) and enjoy your upgraded brakes!!!

15" wheels fit fine. If any of you have 14" wheels, you may want to see if they'll clear. They may not.

So you end up with the same rotor surface area as the Integra/EX upgrade, but you're upgrading to ITR quality calipers, larger pads etc. Not too shabby!

You can instead opt to shave 2.5mm off of the caliper anchor bracket if you don't want to run a spacer.

NOTE: I did not write this article. I found it and thought I would share it with every one who doesnt know about the so called "Jonathan Mod".
Crashing a Honda is like kicking a puppy; Its just sad.
Posts: 144
Joined: Sat Nov 24, 2007 4:34 am
Location: kc mo.

Re: Brake upgrade "Jonathan Mod"

Postby gregy » Sat Sep 08, 2012 6:20 am

wasn't familiar with this jonathan mod but I got a lot of ideas here haha, thanks for sharing
Registered User
Registered User
Posts: 11
Joined: Sat Sep 08, 2012 5:57 am

Return to How-To's

Who is online

Users browsing this forum: No registered users and 1 guest