Page 1 of 1

i need help

Posted: Tue Apr 30, 2019 3:45 am
by efwiring
hello everyone names mike , here seeking some help. I recently did a swap on my 1991 Civic sedan DX from Dual point-to-multipoint and then OBD1 apparently I screwed up somewhere or something . I drive it around for a little bit and I had a check engine light on so brought it back in the garage to fix what the check engine light was blinking about (which was cyp sensor had wires backward)now my main relay is only getting power on the number one wire and I don't know how to track the problem down and fix it. I've done multiple tests and I have multiple main relays they all test fine hopefully somebody could help cuz I don't want to push the car outside and set it on fire but that's about where I'm at it's been over a month my car's been down any help would be appreciated

Re: i need help

Posted: Tue Apr 30, 2019 5:07 am
by 88lxer
hi mike. sorry to hear about your wiring woes. i have a useful instruction document that could help. pm me and i can send you a pdf.